WIRING INSTRUCTIONS FOR FITTING A SMITHS ELECTRONIC SPEEDOMETER TO YOUR DAX
Information from DJ Sportscars
- Ensure that the battery -ve lead is disconnected
- Join a further two wires to the Green +ve feed wire in the Dax loom that runs to the rear of the tachometer
unit. Connect one of these wires to the Green wire in the electronic speedometer's short connection plug harness
(Pin 8) and the other wire to one of the speed sensor wires
- Connect the remaining speed sensor wire to the White/Black wire in the electronic speedometer's short connection
plug harness (Pin 3)
- Join an additional wire to the Black earth wire in the Dax loom that runs to the rear of the tachometer unit
and connect this to the Black wire in the electronic speedometer's short connection plug harness (Pin 4)
- Connect the Red/White wire in the electronic speedometer's short connection plug harness (Pin 5) to the Red/White
dash power wire in the Dax loom
- Reconnect the battery -ve lead and test